MENU  

Design + Structure

Design

G-Shock watch blueprint Case design offering protection against free-fall shocks
A prominent bezel configuration was adopted to prevent the buttons and glass from contacting flat surfaces, thus protecting them from shocks when falling at any angle. This design concept stressing protection from shocks is basic to every G-Shock case design, and the same protective structure is employed not only for our urethane cases, but also for our mm teal cases and analog watch cases.

Urethane band that acts as a shock absorber
The band actually acts as a shock absorber itself, protecting against shocks from behind. We have established strict standards for the combination ratio of urethane resin employed. Neither too soft nor too hard, the superb specified combination realizes an ideal balance between shock resistance and comfortable wear-ability.

G-Shock watch blueprint Shock-resistant metal band that prevents drop shocks
This band is constructed of scratch-resistant pieces. Damage from shock is prevented, even if the watch is dropped, by a structure that defends against shocks by employing wide intervals at the connection points between the band pieces, and adopting a flexible, 150-degree range of band movement.



Structure

G-Shock Technology Born from the breakthrough idea of a hollow structure
The case employs a hollow structure in which the module is "floated" to protect it from shocks. A full urethane bezel provides all-directional enclosure to prevent direct shocks from striking the glass and buttons. And cushioning material provides extra protection for the key parts such as the crystal oscillator inside the module. These and other shock-resistant technologies, exclusive to G-Shock, are spread generously throughout the body and the module interior to raise toughness to the highest levels.

Hollow-structure case
If we tried to absorb shocks simply by encasing the module with urethane resin or other such materials, the case would grow to immense proportions.

G-Shock realizes high shock resistance by supporting the module inside the case at just a few points, thus creating a situation as if the module were floating in air.

G-Shock watch blueprint All-directional covering
Direct shocks to the buttons and the glass surface are prevented by a protective urethane-resin bezel design. Shock resistance has been ensured by inserting cushioning material between the bezel and case in metal models with lower shock-absorption capabilities.

Protection of important parts with cushioning material The crystal oscillator and other important parts inside the module are individually protected with cushioning material. This prevents contact failures and improper operation due to distortions that could otherwise occur inside the module if the watch experience a sudden strong impact.

Shock Resistant Videos